Hey;
I'm new to Linux, much less CodeWeavers.
Running Ubuntu 7.10
Where do I start to get my HP Scanner software to work thru CodeWeaver..?
Installed just fine.
How do I 'tweek' it to get it to run...?
Thnx,
Bill
Important Information These are community forums and not official technical support. If you need official support: Contact Us
The following comments are owned by whoever posted them. We are not responsible for them in any way.
Back to Threads Reply to Thread
Hey;
I'm new to Linux, much less CodeWeavers.
Running Ubuntu 7.10
Where do I start to get my HP Scanner software to work thru CodeWeaver..?
Installed just fine.
How do I 'tweek' it to get it to run...?
Thnx,
Bill
The scanner most likely needs a hardware driver to work, and drivers are not supported in CrossOver. In general you can't use CrossOver to talk to hardware that doesn't have a Linux/Mac driver. If your scanner has a Linux/Mac driver, the scanner software should just work using the SANE->TWAIN bridge in CrossOver, but if you had a Linux driver then you'd probably not ask about the Windows software...
CrossOver Forums: the place to discuss running Windows applications on Mac and Linux
