Important Information These are community forums and not official technical support. If you need official support: Contact Us
The following comments are owned by whoever posted them. We are not responsible for them in any way.
Back to Threads Reply to Thread
I'm trying to run a program that requires a USB dongle. I can run the dongle installer without error, and I can run the program installer without error. However, when I run the application, the application does not see the USB driver and keeps me in "demo" mode.
Anyone have any ideas or suggestions for getting the application to see the USB dongle?
Thanks!
(BTW, if anyone is curious, the application is Forensic Tool Kit by Access Data)
I've had a similar situation with an "unsupported software" Info Select.
My workaround was to close the computer, unplug the 'USB dongle', re-boot, re-boot CrossOver, then plug in the dongle.
The system would then recognise the dongle, BUT.......... later if you at any time close the access to the dongle, it will disappear, and the whole process needs to be repeated to make the dongle appear again.
I hope this helps. It's not really an answer but it is a temporary 'workaround'.
Please Note: This Forum is for non-application specific questions relating to installation/configuration of CrossOver. All application-specific posts to this Forum will be moved to their appropriate Compatibility Center Forum.
CrossOver Forums: the place to discuss running Windows applications on Mac and Linux
